Configuring Floor Plan Zones

Configure zones on a floor plan to support Location Engine generation of area change events.

Define up to 16 specific zones per floor to determine whether a client position is inside or outside of each zone. Additionally, you can create areas located inside of other areas. A client can only be located in one area at a time.

Note

Note

You must have a floor plan displayed to enable the Draw Zones feature.

To draw a zone on the floor plan map:

  1. Go to Configure > Sites. Add a new site or select a site and select Floor Plans tab.
  2. Select Draw Tools to display floor plan tools.
  3. Under Draw Zones, select , then click the map and draw the first line.
  4. Click again to draw a second line and so forth.
  5. When you are finished drawing the zone, double-click to release your cursor.
  6. Right-click the zone to configure Zone Name and Zone ID.
  7. To edit an existing zone, select and click one of the lines of the zone.
  8. Drag your cursor to change the zone area.
  9. Double-click to release your cursor.
  10. Click Save to save the floor plan.
9038996-00 Rev. AB